show clock
\nshow interace fastethernet 0\/N
\nshow ip dhcp binding
\nshow ip interface brief
\nshow ip route
\nshow running-config<\/p>\n
Sw1#show interface fastethernet 0\/2<\/span><\/pre>\nFastEthernet0\/2 is up, line protocol is up (connected)<\/pre>\nFastEthernet0\/2 is up = Status (Physical Layer)
\nline protocol is up = Protocol (Data Link Layer)<\/p>\n
Hardware is Lance, address is 0001.c7d6.bb02 (bia<\/strong> 0001.c7d6.bb02)<\/pre>\nbia = Built In Address = MAC address for the switchport<\/p>\n
BW 100000 Kbit, DLY 1000 usec,\r\n reliability<\/strong> 255\/255, txload<\/strong> 1\/255, rxload<\/strong> 1\/255<\/pre>\nReliability = 255\/255 = 100% Reliable = 1=0 && 255=100
\ntxload = Transmitting Load: 1\/255 = very low, 255\/255 = full load
\nrxload = Receiving Load<\/p>\n
Encapsulation ARPA, loopback not set\r\n Keepalive set (10 sec)\r\n Full-duplex, 100Mb\/s<\/strong>\r\n input flow-control is off, output flow-control is off\r\n ARP type: ARPA, ARP Timeout 04:00:00\r\n Last input 00:00:08, output 00:00:05, output hang never\r\n Last clearing of \"show interface\" counters never\r\n Input queue: 0\/75\/0\/0 (size\/max\/drops\/flushes); Total output drops: 0\r\n Queueing strategy: fifo\r\n Output queue :0\/40 (size\/max)\r\n 5 minute input rate 0 bits\/sec, 0 packets\/sec<\/strong>\r\n 5 minute output rate 0 bits\/sec, 0 packets\/sec<\/strong><\/pre>\nThe following information is Historical Data<\/p>\n
956 packets<\/strong> input, 193351 bytes, 0 no buffer\r\n Received 956 broadcasts<\/strong>, 0 runts, 0 giants, 0 throttles<\/pre>\nTo calculate percentage of broadcasts: # Broadcasts \/ # Packets Input
\nAverage usually about 20%
\nRunts: Packets that are too small
\nGiants: Packets that are too large
\nRunts & Giants generally caused by bad connections<\/p>\n
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort\r\n 0 watchdog, 0 multicast, 0 pause input\r\n 0 input packets with dribble condition detected\r\n 2357 packets output, 263570 bytes, 0 underruns\r\n 0 output errors, 0 collisions, 10 interface resets\r\n 0 babbles, 0 late collision, 0 deferred<\/pre>\nCollisions generally caused by:<\/p>\n
\n- Cable is too long<\/li>\n
- Duplex mismatch (most common)<\/li>\n<\/ul>\n
Late Collisions may occur if # hops between src and dest is too great.<\/p>\n
\n- This causes a packet to become delayed<\/li>\n
- The Source resends the packet because it did not receive an ACK<\/li>\n
- The new, repeat packet arrives<\/li>\n<\/ul>\n
0 lost carrier, 0 no carrier
\n0 output buffer failures, 0 output buffers swapped out<\/p>\n
<\/p>\n
show ip dhcp binding<\/h3>\n
This command displays the IP and MAC addresses, along with the lease exiration date and time for IP addresses handed out via DHCP.<\/p>\n
r3#show ip dhcp binding<\/span> \r\nBindings from all pools not associated with VRF: \r\nIP address Client-ID\/ Lease expiration Type \r\n Hardware address\/ \r\n User name \r\n192.168.33.20 b827.eb62.35b2 Jan 21 2017 04:43 PM Automatic<\/pre>\n <\/p>\n
show ip interface brief<\/h3>\n
Will provide a report of all interfaces on the switch, and their current status.<\/p>\n
Sw1#show ip interface brief<\/span> \r\nInterface IP-Address OK? Method Status Protocol\r\nFastEthernet0\/1 unassigned YES manual up up\r\nFastEthernet0\/2 unassigned YES manual up up\r\nFastEthernet0\/3 unassigned YES manual down down\r\nFastEthernet0\/4 unassigned YES manual administratively down down\r\n...\r\nFastEthernet0\/23 unassigned YES manual down down\r\nFastEthernet0\/24 unassigned YES manual down down\r\nVlan1 172.2.30.180 YES manual up\r\n<\/pre>\nStatus:Physical Layer
\nProtocol: Data Link Layer<\/p>\n
show running-config<\/h3>\n
Displays the actual configuration of the switch.
\nThis is essentially a list of all configuration commands being currently used.<\/p>\n
During the Cisco test, it is common to have this command disabled to force you to use different commands to find the problem!<\/div>\n <\/p>\n
Sw1#show running-config<\/span>\r\nBuilding configuration...\r\n\r\nCurrent configuration : 1386 bytes\r\n!\r\nversion 12.1\r\nno service timestamps log datetime msec\r\nno service timestamps debug datetime msec\r\nservice password-encryption\r\n!\r\nhostname Sw1\r\n!\r\nenable secret 5 $1$mERr$GvDaTJK9lhdXRUPWKA74O0\r\n!\r\nip ssh version 2\r\nip domain-name sw1.switch.com\r\n!\r\nusername thomas privilege 1 password 7 08314D5D1A0E0A0516\r\n!\r\nspanning-tree mode pvst\r\n!\r\ninterface FastEthernet0\/1\r\n switchport mode access\r\n switchport port-security\r\n!\r\ninterface FastEthernet0\/2\r\n switchport mode access\r\n!\r\ninterface FastEthernet0\/3\r\n!\r\n...\r\ninterface FastEthernet0\/22\r\n!\r\ninterface FastEthernet0\/23\r\n!\r\ninterface FastEthernet0\/24\r\n!\r\ninterface Vlan1\r\n ip address 172.2.30.180 255.255.255.0\r\n!\r\nip default-gateway 172.2.30.1\r\n!\r\nbanner motd ^C\r\n\r\n***\r\nKeep Out!\r\n***\r\n\r\n^C\r\n!\r\nline con 0\r\n password 7 08314D5D1A0E0A0516\r\n login\r\n!\r\nline vty 0 4\r\n exec-timeout 60 0\r\n password 7 08314D5D1A0E0A0516\r\n login\r\n transport input ssh\r\nline vty 5 15\r\n login\r\n!\r\n!\r\nend<\/pre>\n <\/p>\n
Routing and Routing Protocols<\/h1>\n
Routing Protocols include:<\/p>\n
\n- rip<\/li>\n
- eigrp<\/li>\n
- ospf<\/li>\n
- is-is<\/li>\n
- bgp<\/li>\n<\/ul>\n
Current Routes<\/h2>\nshow ip route<\/pre>\n <\/p>\n
Configured Protocols<\/h2>\nshow ip protocols<\/pre>\n <\/p>\n
Routing Configuration<\/h2>\nshow run | begin <routing protocol><\/pre>\n <\/p>\n
Routing Databases<\/h2>\nshow ip <routing protocol> database<\/pre>\n <\/p>\n
Routing Neighbors<\/h2>\nshow ip <routing protocol> neighbors<\/pre>\n <\/p>\n
<\/p>\n","protected":false},"excerpt":{"rendered":"
Main Menu show clock show interace fastethernet 0\/N show ip dhcp binding show ip interface brief show ip route show running-config show interface fastethernet 0\/N Sw1#show interface fastethernet 0\/2 FastEthernet0\/2 is up, line protocol is up (connected) FastEthernet0\/2 is up = Status (Physical Layer) line protocol is up = Protocol (Data Link Layer) Hardware is ..<\/p>\n